After the dust collector has passed the trial operation, some problems may occur during the normal operation of the dust collector equipment. For these problems, we need to adjust in time
We all know that the newly purchased dust collector-related products need to pass the standard test run inspection before they can be put into use. The dust collector should pay attention to whether the fan, bearing, filter bag and other parts can work normally during the test run. , And pay attention to whether its working temperature and processing air volume are within the qualified range. When the inspection finds that there is no problem, the performance experiment of some functions of the dust collector can be carried out.
Therefore, during the trial operation of the dust collector, we need to be cautious and pay attention to the following points:
1. We need to pay attention to the speed and direction of the fan and the temperature of the bearing vibration frequency.
2. When dealing with air volume and test points, first check whether the pressure, temperature and other data are consistent with the design. If they do not, we need to adjust them in time.
3. For the installation of the dust collector, first check whether there are hanging bags, wear, etc., and at the same time visually check the emission of the chimney, so as to grasp the information in time.
4. It is necessary to pay attention to whether the dust collector equipment has bag condensation, whether the ash discharge system is unobstructed and whether the accumulation of ash will affect the operation of the host.
5. Adjust the cleaning time. The cleaning operation has a great impact on the operation of the machine. After a long time, the dust is easy to fall. If the time is too short, the filter will be restored and the resistance will increase, and the former may also cause the bag filter to leak And breakage, so we have to pay attention to this.
Post time: Dec-30-2021