Furniture factory woodworking dust collector selection
1. Dust dispersion has a great influence on the furniture factory woodworking dust collector. Therefore, when selecting the dust collector for the furniture factory, it can be selected according to the dispersion degree of dust. In the selection of furniture factory dust collector, it should also be considered from the site dust volume and dust medium and other comprehensive factors, can be determined by referring to the technical parameters and type of dust collector, general equipment manufacturers will give corresponding suggestions.
2. In the dust collector of gravity and inertia, the power of the dust collector of furniture factory imported with large dust content is higher, which will increase the dust content of the export, and can not make the dust collector have a good power. Equipment in the filter type dust collector, the initial dust concentration is low, the overall dust removal function is better. Therefore, it is better to use the woodworking dust collector in furniture factory in the range of initial dust concentration below 30g/Nm3.
Furniture factory woodworking dust collector maintenance:
The performance of the dust collector is expressed by the amount of gas that can be treated, the resistance loss and dust removal efficiency when the gas passes through the dust collector. There will be some wear parts in the process of long-time use. In order to make the parts not affect the operation of the whole equipment, then the woodworking dust collector can not be ignored in the daily repair and maintenance:
1. When starting up, the compressed air should be connected to the air storage tank first, and then the control power should be connected to start the ash discharge device. But if there are other devices in the system, the downstream equipment should be started first.
2, shut down, to ensure that the dust removal accessories and exhaust fan can continue to work for a period of time, but it needs to be noted that when the dust removal accessories stop working, the dust removal accessories should be repeatedly cleaned, to remove the dust on the dust filter bag, so as not to cause the paste bag because of the influence of moisture.
3. When the machine is shut down, the compressed air source need not be cut off, especially when the fan is working, the compressed air should be provided to the lifting valve cylinder to ensure the lifting
Post time: Feb-10-2022